
44 45
Set the Hypoglycemic Limit (flashing) with the
RIGHT or LEFT arrow buttons. Press CENTER
button to confirm and continue on to set the
Hyper Limit.
[4] Setting Your Hyperglycemic Warning Alarm:
WARNING: Your healthcare professional should recommend
what your hyperglycemic limit is.
The Hyperglycemic Warning Alarm alerts you when your
glucose test results are above the hyperglycemic limit that you
have set. The meter is pre-set to a hyperglycemic limit of 240
mg/dL. Always consult your healthcare professional for your
recommended target ranges. When your glucose test results are
above your set hyperglycemic limit, the date, time and result will
flash on the display.
Set the Hyperglycemic Limit ON or OFF with the
RIGHT or LEFT arrow buttons. Your selection will
be highlighted by the blinking of the symbol. Press
the CENTER button to confirm your selection.
Set the Hyperglycemic Limit (flashing) with the
RIGHT or LEFT arrow buttons. Press the CENTER
button to confirm. This will bring you back to
MENU Mode at the SET options.
Error Messages and
Troubleshooting
16
CHAPTER
The AgaMatrix Presto Blood Glucose Monitoring System
has been designed to work accurately under most usual
conditions. On rare occasions, the meter will display an error
message instead of a glucose result. The AgaMatrix Presto
system is able to detect specific problems which may allow
you to determine the cause of the error without wasting
valuable test strips. When you are presented with an error
message, check for common problems that may explain the
source of the error.
CAUTION: In certain cases, the meter may return an error
code or provide an inaccurate result if it is being used near
electrical equipment, like a power generator or a computer
monitor. If this is the case, move the meter away from the
source of electrical interference.
Error 1:
Problems have occurred that are related to test strip use.
[1] If this message appears the moment the test strip is
inserted, the test strip may be wet or damaged.
[2] If the message appears during a test, the test strip may
have been removed too early.
[3] If this message appears after the last progress bar instead
of a result, it may indicate that you applied more blood after
testing began.
Comentários a estes Manuais